Refine
Has Fulltext
- no (19) (remove)
Year of Publication
- 2010 (19) (remove)
Document Type
- Peer-Reviewed Article (19) (remove)
Comparative analysis of environmental impacts of maize-biogas and photovoltaics on a land use basis
(2010)
This study aims to stimulate the discussion on how to optimize a sustainable energy mix from an environmental perspective and how to apply existing renewable energy sources in the most efficient way. Ground-mounted photovoltaics (PV) and the maize-biogas-electricity route are compared with regard to their potential to mitigate environmental pressure, assuming that a given agricultural area is available for energy production. Existing life cycle assessment (LCA) studies are taken as abasis to analyse environmental impacts of those technologies in relation to conventional technology for power and heat generation. The life-cycle-wide mitigation potential per area used is calculated for the impact categories non-renewable energy input, green house gas (GHG) emissions, acidification and eutrophication. The environmental performance of each system depends on the scenario that is assumed for end energy use (electricity and heat supply have been contemplated). In all scenarios under consideration, PV turns out to be superior to biogas in almost all studied impact categories. Even when maize is used for electricity production in connection with very efficient heat usage, and reduced PV performance is assumed to account for intermittence, PV can still mitigate about four times the amount of green house gas emissions and non-renewable energy input compared to maize-biogas. Soil erosion, which can be entirely avoided with PV, exceeds soil renewal rates roughly 20-fold on maize fields. Regarding the overall Eco-indicator 99 (H) score under most favourable assumptions for the maize–biogas route, PV has still a more than 100% higher potential to mitigate environmental burden. At present, the key advantages of biogas are its price and its availability without intermittence. In the long run, and with respect to more efficient land use, biogas might preferably be produced from organic waste or manure, whereas PV should be integrated into buildings and infrastructures.
Renania del Norte-Westfalia (RNW) es el mayor estado federal (land) de la República Federal de Alemania. Hasta la década de 1970, la región del Rin-Ruhr, con una población de unos 12 millones de habitantes y una potente industria química, del carbón y del acero, se vio afectada por graves problemas de contaminación. En los años setenta, la protección medioambiental apareció en las agendas políticas nacionales e internacionales. Los gobiernos federales y el estatal lanzaron múltiples intervenciones legislativas y económicas para limpiar ríos, suelos y aire. Como resultado, surgió una ecoindustria muy competitiva. En este artículo, se resumen las características de las ecoindustrias y se describe el cambio estructural de la región del Ruhr. Asimismo, centrándose en el mesonivel y empleando los ejemplos de la gestión energética y la gestión municipal de residuos, se destacan los puntos fuertes y los puntos débiles de las políticas económicas regionales de clusters que apoyan las ecoindustrias en RNW.
For parabolic trough power plants using synthetic oil as the heat transfer medium, the application of solid media sensible heat storage is an attractive option in terms of investment and maintenance costs. One important aspect in storage development is the storage integration into the power plant. A modular operation concept for thermal storage systems was previously suggested by DLR, showing an increase in storage capacity of more than 100 %. However, in these investigations, the additional costs needed to implement this storage concept into the power plant, like for extra piping, valves, pumps and control had not been considered. These aspects are discussed in this paper, showing a decrease of levelized energy costs with modular storage integration of 2 to 3 %. In a Life Cycle Assessment (LCA) a comparison of an AndaSol-I type solar thermal power plant [1] with the original two-tank molten salt storage and with a "hypothetical" concrete storage shows an advantage of the concrete storage technology concerning environmental impacts. The environmental impacts of the “hypothetical” concrete based AndaSol-I decrease by 7 %, considering 1 kWh of solar electricity delivered to the grid. Regarding only the production of the power plant, the emissions decrease by 9.5 %.
This study provides insight into the feasibility of a CO2 trunkline from the Netherlands to the Utsira formation in the Norwegian part of the North Sea, which is a large geological storage reservoir for CO2. The feasibility is investigated in competition with CO2 storage in onshore and near-offshore sinks in the Netherlands. Least-cost modelling with a MARKAL model in combination with ArcGIS was used to assess the cost-effectiveness of the trunkline as part of aDutch greenhouse gas emission reduction strategy for the Dutch electricity sector and CO2 intensive industry. The results show that under the condition that a CO2 permit price increases from €25 per tCO2 in 2010 to €60 per tCO2 in 2030, and remains at this level up to 2050, CO2 emissions in the Netherlands could reduce with 67% in 2050 compared to 1990, and investment in the Utsira trunkline may be cost-effective from 2020–2030 provided that Belgian and German CO2 is transported and stored via the Netherlands as well. In this case, by 2050 more than 2.1 GtCO2 would have been transported from the Netherlands to the Utsira formation. However, if the Utsira trunkline is not used for transportation of CO2 from Belgium and Germany, it may become cost-effective 10 years later, and less than 1.3 GtCO2 from the Netherlands would have been stored in the Utsiraformation by 2050. On the short term, CO2 storage in Dutch fields appears more cost-effective than in the Utsira formation, but as yet there are major uncertainties related to the timing and effective exploitation of the Dutch offshore storage opportunities.
Northrhine-Westphalia (NRW) is the largest land of the Federal Republic of Germany. Until the 1970ies the Ruhr-area with a population of about 12 million people and a strong coal, steel and chemical industry had been plagued with severe pollution. In the 1970ies environmental protection had emerged on the international and national policy agendas. The federal and regional government launched massive legislative and economic public interventions for cleaning-up rivers, soils and air. As a result, a highly competitive eco-industry emerged. The article outlines main features of ecoindustries, the structural change of the Ruhr area and regional economic cluster policies in support of eco-industries in NRW. It draws conclusions for eco-industry policy developing from end-of-pipe towards integrated preventive approaches.
Natural gas makes an increasing contribution to the European Union's energy supply. Due to its efficiency and low level of combustion emissions this reduces greenhouse gas emissions compared to the use of other fossil fuels. However, being itself a potent greenhouse gas, a high level of direct losses of natural gas in its process chain could neutralise these advantages. Which effect will finally prevail depends on future economical as well as technical developments. Based on two different scenarios of the main influencing factors we can conclude that over the next two decades CH4 emissions from the natural gas supply chain can be significantly reduced, in spite of unfavourable developments of the supply structures. This, however, needs a substantial, but economically attractive investment into new technology, particularly in Russia.
New technologies can be the basis for resource-efficient products and services and thus create eco-innovations, either by creating new functionalities in existing or new application fields or by substituting existing technologies in existing or new application fields. In this paper, an overview over different technology fields, products and strategies with resource efficiency potential, such as nanotechnolo- gies, material science, manufacturing technologies, process technologies and cross-cutting issues, is presented. There is a special focus on applications from nanotechnology issuing, e.g. functional surfaces or new "smart" materials with special functionalities. Furthermore, it is shown how companies can use the method Resource Efficiency Technology Radar to identify and evaluate technolo- gies with resource efficiency in order to incorporate them into their development activities.
This article addresses informational barriers to energy efficiency. It is a widely acknowledged result that an energy efficiency gap exists implying that the level of energy efficiency is at an inefficiently low level. Several barriers to energy efficiency create this gap and the presence of asymmetric information is likely to be one such barrier. The article finds that problems of moral hazard and adverse selection indeed can help explain the seemingly low levels of energy efficiency. The theory reveals two implications to policies on energy efficiency. First, the development of measures to enable contractual parties to base remuneration on energy performance must be enhanced, and second, the information on technologies and the education of consumers and installers on energy efficiency must be increased. Finally, it is found that the preferred EU policy instrument on energy efficiency, so far, seems to be the use of minimum requirements. Less used in EU legislation is the use of measuring and verification as well as the use of certifications. Therefore, it is concluded that the EU should consider an increased use of these instruments.
Japan
(2010)