Refine
Document Type
- Report (9)
- Peer-Reviewed Article (8)
- Contribution to Periodical (3)
CCS is discussed in a broad sense throughout Europe. In this paper a cautious, conservative estimate of CO2 storage capacity for Germany and its neighbouring countries where CO2 emissions from Germany could possibly be stored (Netherlands, France, Denmark, Norway, UK and Poland) is presented. Such a lower limit calculation is necessary for orientation purposes for potential investors and political decision-makers.
Conservative CO2 sequestration capacity in deep saline aquifers for Germany is derived by the volumetric approach where parameters such as efficiency factor, CO2 density, porosity of the geological formation are of interest. It is assumed that every geological system is closed and thus an efficiency factor of 0.1 per cent (based on maximum pressure increase and total compressibility) for saline aquifers is applied. The capacity of German depleted oil and gas fields is based on cumulative recovery data and a sweep efficiency of 75 per cent. The storage capacity in the other considered countries, adjacent to Germany, are based on a critical review and adjustment of the results of the European reports JOULE II, GESTCO and GeoCapacity.
The conservative capacities for all countries together amount to 49 Gt CO2, from which Norway and the UK provide 36 Gt, all offshore in the North Sea. Compared to the emissions from large point sources in these countries during 40 years (47.6 Gt of CO2), a virtual balance is achieved. This can only be reached, if a large scale CO2 pipeline system is installed to connect these countries, especially Germany, to the large sinks in the North Sea. If additional restrictions like source-sink matching, acceptance issues and injection rates constraints are taken into account, the available storage space gets increasingly scarce.
The CO2 utilisation is discussed as one of the future low-carbon technologies in order to accomplish a full decarbonisation in the energy intensive industry. CO2 is separated from the flue gas stream of power plants or industrial plants and is prepared for further processing as raw material. CO2 containing gas streams from industrial processes exhibit a higher concentration of CO2 than flue gases from power plants; consequentially, industrial CO2 sources are used as raw material for the chemical industry and for the synthesis of fuel on the output side. Additionally, fossil resources can be replaced by substitutes of reused CO2 on the input side. If set up in a right way, this step into a CO2-based circular flow economy could make a contribution to the decarbonisation of the industrial sector and according to the adjusted potential, even rudimentarily to the energy sector.
In this study, the authors analyse potential CO2 sources, the potential demand and the range of applications of CO2. In the last chapter of the final report, they give recommendations for research, development, politics and economics for an appropriate future designing of CO2 utilisation options based upon their previous analysis.
One of the factors decelerating a further diffusion of the carbon capture and storage (CCS) technology is the public's negative perception of early pilot or demonstration activities in Germany as well as in other countries. This study examined the public perception of CCS in more detail by looking into different options within the CCS chain, i.e. for the three elements capture, transport and storage. This was analyzed using an experimental approach, realized in an online survey with a representative German sample of 1830 citizens. Each participant evaluated one of 18 different CCS scenarios created using three types of CO2 source (industry, biomass, coal), two transport options (pipeline vs. no specification), and three storage possibilities (saline aquifer, depleted gas field, enhanced gas recovery (EGR)).
Overall, we found that the ratings of CCS were neutral on average. However, if the CO2 is produced by a biomass power plant or industry, CCS is rated more positively than in a scenario with a coal-fired power plant. The specifications of transport and storage interacted with each other such that scenarios including EGR or a depleted gas field without mentioning a pipeline were evaluated better than storing it in a saline aquifer or a depleted gas field and mentioning a pipeline as means of transport. Exploratory regression analyses indicate the high relevance of the respective CO2 source in general as well as the perceived importance of this source for Germany.
Facing the uncertainty of CO2 storage capacity in China by developing different storage scenarios
(2016)
China is very active in the research and development of CO2 capture and storage technologies (CCS). However, existing estimates for CO2 storage capacity are very uncertain. This uncertainty is due to limited geological knowledge, a lack of large-scale research on CO2 injection, and different assessment approaches and parameter settings. Hence storage scenarios represent a method that can be used by policy makers to demonstrate the range of possible storage capacity developments, to help interpret uncertain results and to identify the limitations of existing assessments. In this paper, three storage scenarios are developed for China by evaluating China-wide studies supplemented with more detailed site- and basin-specific assessments. It is estimated that the greatest storage potential can be found in deep saline aquifers. Oil and gas fields may also be used. Coal seams are only included in the highest storage scenario. In total, the scenarios presented demonstrate that China has an effective storage capacity of between 65 and 1551 Gt of CO2. Furthermore, the authors emphasise a need for action to harmonise storage capacity assessment approaches due to the uncertainties involved in the capacity assessments analysed in this study.