Zukünftige Energie- und Industriesysteme
Urbanization and climate change are amongst the greatest challenges of the 21st century. In the "Low Carbon Future Cities" project (LCFC), three important problem dimensions are analysed: current and future GHG emissions and their mitigation (up to 2050); resource use and material flows; and vulnerability to climate change.
The industrial city of Wuxi has been the Chinese pilot city of the project. To establish the pathway for a low carbon future, it is crucial to understand the current situation and possible future developments. The paper presents the key results of the status quo analysis and the future scenario analysis carried out for Wuxi. Two scenarios are outlined. The Current Policy Scenario (CPS) shows the current most likely development in the area of energy demand and GHG emissions until 2050. Whereas the extra low carbon scenario (ELCS) assumes a significantly more ambitious implementation, it combines a market introduction of best available technologies with substantial behavioural change. All scenarios are composed of sub-scenarios for the selected key sectors.
Looking at the per capita emissions in Wuxi, the current levels are already high at around 12 tonnes CO2 per capita compared to Western European cities. Although Wuxi has developed a low carbon plan, the projected results under current policies (CPS) show that the total emissions would increase to 23.6 tonnes CO2 per capita by 2050. If the ELCS pathway was to be adopted, these CO2 emission levels could be reduced to 6.4 tonnes per capita by 2050.
The German federal state of North Rhine-Westphalia (NRW) is home to one of the most important industrial regions in Europe, and is the first German state to have adopted its own Climate Protection Law (CPL). This paper describes the long-term (up to 2050) mitigation scenarios for NRW’s main energy-intensive industrial sub-sectors which served to support the implementation of the CPL. It also describes the process of scenario development, as these scenarios were developed through stakeholder participation. The scenarios considered three different pathways (best-available technologies, break-through technologies, and CO2 capture and storage). All pathways had optimistic assumptions on the rate of industrial growth and availability of low-carbon electricity. We find that a policy of "re-industrialisation" for NRW based on the current industrial structures (assumed here to represent an average growth of NRWs industrial gross value added (GVA) of 1.6% per year until 2030 and 0.6% per year from 2030 to 2050), would pose a significant challenge for the achievement of overall energy demand and German greenhouse gas (GHG) emission targets, in particular as remaining efficiency potentials in NRW are limited. In the best-available technology (BAT) scenario CO2 emission reductions of only 16% are achieved, whereas the low carbon (LC) and the carbon capture and storage (CCS) scenario achieve 50% and 79% reduction respectively. Our results indicate the importance of successful development and implementation of a decarbonised electricity supply and breakthrough technologies in industry - such as electrification, hydrogen-based processes for steel, alternative cements or CCS - if significant growth is to be achieved in combination with climate mitigation. They, however, also show that technological solutions alone, together with unmitigated growth in consumption of material goods, could be insufficient to meet GHG reduction targets in industry.
The CO2 utilisation is discussed as one of the future low-carbon technologies in order to accomplish a full decarbonisation in the energy intensive industry. CO2 is separated from the flue gas stream of power plants or industrial plants and is prepared for further processing as raw material. CO2 containing gas streams from industrial processes exhibit a higher concentration of CO2 than flue gases from power plants; consequentially, industrial CO2 sources are used as raw material for the chemical industry and for the synthesis of fuel on the output side. Additionally, fossil resources can be replaced by substitutes of reused CO2 on the input side. If set up in a right way, this step into a CO2-based circular flow economy could make a contribution to the decarbonisation of the industrial sector and according to the adjusted potential, even rudimentarily to the energy sector.
In this study, the authors analyse potential CO2 sources, the potential demand and the range of applications of CO2. In the last chapter of the final report, they give recommendations for research, development, politics and economics for an appropriate future designing of CO2 utilisation options based upon their previous analysis.