Zukünftige Energie- und Industriesysteme
The energy potential of agricultural residues in Tanzania has so far not been evaluated and quantified sufficiently. Moreover, the scientific basis for estimations of the sustainable potential of wastes and residues is still very limited. This paper presents an attempt to evaluate the theoretical and technical potential of residues from the sisal sector in Tanzania with regards to energy recovery through anaerobic digestion. The characteristics and availability of sisal residues are defined and a set of sustainability indicators with particular focus on environmental and socio-economic criteria is applied. Our analysis shows that electricity generation with sisal residues can be sustainable and have positive effects on the sustainability of sisal production itself. All sisal residues combined have an annual maximum electricity potential of 102 GW h in 2009, corresponding to up to 18.6 MW of potential electric capacity installations. This estimated maximum potential is equivalent to about 3 % of the country's current power production. Utilizing these residues could contribute to meeting the growing electricity demand and offers an opportunity for decentralized electricity production in Tanzania.
This paper examines the effects of an increased integration of concentrated solar power (CSP) into the conventional electricity systems of Morocco and Algeria. A cost-minimizing linear optimization tool was used to calculate the best CSP plant configuration for Morocco's coal-dominated power system as well as for Algeria, where flexible gas-fired power plants prevail. The results demonstrate that in both North African countries, storage-based CSP plants offer significant economic advantages over non-storage, low-dispatchable CSP configurations. However, in a generalized renewable integration scenario, where CSP has to compete with other renewable generation technologies, like wind or photovoltaic (PV) power, it was found that the cost advantages of dispatchability only justify CSP investments when a relatively high renewable penetration is targeted in the electricity mix.
Die atompolitische Wende der Bundesregierung hatte zahlreichen Spekulationen und Befürchtungen Raum gegeben. Es wurde gemutmaßt, dass Deutschland zum Nettostromimporteur werden könnte, sollten die Kraftwerke (wie im Sommer 2011 beschlossen) dauerhaft außer Betrieb bleiben. Darüber hinaus nahm man an, dass die in Deutschland entfallende Stromerzeugung durch Kohlekraftwerke oder durch Importe aus französischen oder tschechischen Atomkraftwerken ersetzt würde und dass Strompreise sowie CO2-Emissionen deutlich ansteigen würden. Inzwischen liegen vorläufige Energiebilanzen und Marktdaten für das Jahr 2011 vor, die viele dieser Befürchtungen widerlegen. Der hier vorgenommene Ausblick auf die mögliche Entwicklung in den kommenden Jahren zeigt zudem, dass die Bilanz von 2011 keine Momentaufnahme sein muss, sondern dass der gegenüber 2010 wegfallende Kernenergiestrom - bilanziell gesehen - voraussichtlich bereits ab 2013 allein durch eine erhöhte regenerative Stromerzeugung kompensiert werden kann.
Purpose - Iran as an energy-rich country faces many challenges in the optimal utilization of its vast resources. High rates of population and economic growth, a generous subsidies program, and poor resource management have contributed to rapidly growing energy consumption and high energy intensity over the past decades. The continuing trend of rising energy consumption will bring about new challenges as it will shrink oil export revenues, restraining economic activities. This calls for a study to explore alternative scenarios for the utilization of energy resources in Iran. The purpose of this paper is to model demand for energy in Iran and develop two business-as-usual and efficiency scenarios for the period 2005-2030.
Design/methodology/approach - The authors use a techno-economic or end-use approach to model energy demand in Iran for different types of energy uses and energy carriers in all sectors of the economy and forecast it under two scenarios: business as usual (BAU) and efficiency.
Findings - Iran has a huge potential for energy savings. Specifically, under the efficiency scenario, Iran will be able to reduce its energy consumption 40 percent by 2030. The energy intensity can also be reduced by about 60 percent to a level lower than the world average today.
Originality/value - The paper presents a comprehensive study that models the Iranian energy demand in different sectors of the economy, using data at different aggregation levels and a techno-economic end-use approach to illuminate the future of energy demand under alternative scenarios.
Sustainable energy technologies are widely sought-after as essential elements in facing global challenges such as energy security, global warming and poverty reduction. However, in spite of their promising advantages, sustainable energy technologies make only a marginal contribution to meeting energy related needs in both industrialised and developing countries, in comparison to the widespread use of unsustainable technologies. One of the most significant constraints to their adoption and broad diffusion is the socio-economic context in which sustainable energy technologies are supposed to operate. The same holds true for community-based energy projects in developing countries supported by the WISIONS initiative. Practical strategies dealing with these socio-economic challenges are crucial elements for project design and, particularly, for the implementation of project activities. In this paper experiences from implementing community-based projects are reviewed in order to identify the practical elements that are relevant to overcome socio-economic challenges. In order to systematise the findings, an analytical framework is proposed, which combines analytical tools from the socio-technical transition framework and insights from participative approaches to development.
If the current energy policy priorities are retained, there may be no need to focus additionally on carbon capture and storage (CCS) in the power plant sector of Germany. This applies even in the case of ambitious climate protection targets, according to the results of the presented integrated assessment study. These cover a variety of aspects: Firstly, the technology is not expected to become available on a large scale in Germany before 2025. Secondly, if renewable energies and combined heat and power are expanded further and energy productivity is enhanced, there is likely to be only a limited demand for CCS power plants, as a scenario analysis of CCS deployment in Germany shows. Thirdly, cost analysis using the learning curve approach shows that the electricity generation costs of renewable electricity approach those of CCS power plants. This leads to the consequence that, from 2020, several renewable technologies may well be in a position to offer electricity at a cheaper rate than CCS power plants. In addition, a review of new life cycle assessments for CO2 separation in the power plant sector indicates that the greenhouse gas emissions from 1 kW h of electricity generated by first-generation CCS power plants could only be reduced by 68 % to 87 % (95 % in individual cases). Finally, a cautious, conservative estimate of the effective German CO2 storage capacity of approximately 5 billion tonnes of CO2 is calculated, including a fluctuation range yielding values between 4 and 15 billion tonnes of CO2. Therefore, the total CO2 emissions caused by large point sources in Germany could be stored for 12 years (basic value) or for 8 or 33 years (sensitivity values).
Eine oft kontrovers diskutierte Frage ist, ob eine massive Dämmung von Häusern in der Gesamtbilanz nicht mehr Ressourcenverbrauch und Emissionen verursacht, als sie im Endeffekt einspart. Zur Untersuchung dieser Frage wurde nun erstmals eine trade-off Analyse durchgeführt. Hierzu wurde ein bottom-up Wirkungsanalyse-Modell entwickelt, dessen Kern ein Emissions- und Energiemodell für den Haushaltssektor bildet, gekoppelt mit einem Ökobilanzierungs-Tool. Den Rahmen für beide Modelle bilden Energieszenarien bis 2050, die für jede Dekade Sanierungsraten und Energiemixe vorgeben. Damit können "reine" Energieszenarien um ressourcenpolitische Analysen erweitert und die Auswirkungen verschiedener Dämmstrategien ermittelt werden.
Das zentrale Ergebnis der Modellierung ist, dass zusätzliche Aufwendungen für Dämmstoffe (untersucht wurden extrudierter Polystyrolhartschaum XPS und Zellulose) sowohl ressourcen- als auch emissionsseitig in fast allen Umweltwirkungskategorien durch erhebliche Einsparungen bei der Gebäudebeheizung überkompensiert werden. Im Wesentlichen sind keine Trade-offs erkennbar und der prozentuale Beitrag der Dämmstoffe an den Umweltwirkungsindikatoren ist gering. Relevant ist dagegen die Wahl des Treibmittels bei den aufgeschäumten XPS-Dämmstoffen: Gegenüber dem in Deutschland verwendeten XPS, das weitgehend mit CO2 aufgeschäumt wird, führt ein Dämmstoff, der hohe Anteile an Fluorkohlenwasserstoffen aufweist, zu einem hohen Trade-off bezüglich der Wirkungskategorie "stratosphärischer Ozonabbau" und zu einer erkennbaren, jedoch nicht so deutlichen Wirkung auf das Treibhaus-Potenzial. Eine Sensitivitätsanalyse mit dem alternativen Dämmmaterial Zellulose zeigt, dass sich die an sich schon geringen Anteile der Dämmstoffe an den Umweltwirkungsindikatoren weiter verringern. Hinsichtlich der Materialintensität sind XPS- und Zellulose-Dämmung jedoch mit vergleichbaren Auswirkungen verbunden.
Zusammenfassend lässt sich festhalten, dass für beide Materialien ambitionierte Dämmstoffstrategien im Hinblick auf alle in dieser Studie analysierten Faktoren einen wesentlichen Beitrag sowohl zu Materialeffizienz- als auch zu Emissionsminderungszielen leisten können.
Um das vom Weltklimarat (IPCC) geforderte 2°C-Ziel einhalten zu können, ist eine Reduktion der globalen CO2-Emissionen um 80% bis 2050 gegenüber dem Stand von 1990 zwingend notwendig. Hierbei wird auch solarthermischen Kraftwerken eine immer größere Bedeutung beigemessen. Im BLUE Map-Szenario der Internationalen Energieagentur (IEA), das von einer CO2-Reduktion um 50% bis 2050 gegenüber 2005 ausgeht, müssen im Jahr 2050 ca. 11% (4.754 TWh) des weltweiten Strombedarfs durch Sonnenenergie gedeckt werden (IEA 2008). Neben Photovoltaik sollen solarthermische Kraftwerke (Concentrated Solar Power, CSP) etwa 46% (ca. 2.200 TWh) der prognostizierten Menge an Solarstrom erzeugen. Im Energy[R]evolution Szenario von Greenpeace International und EREC (European Renewable Energy Council) aus dem Jahr 2008 werden rund 6.000 TWh an CSP-Strom im Jahr 2050 angenommen (bei einer installierten Leistung von 801 GW), während andere Studien bis zu 1.000 GW installierter Leistung in 2050 betrachten (Viebahn et al. 2010). Die DESERTEC-Initiative gibt ein Ziel von 5.000 GW installierter Leistung im Jahr 2050 vor.
Der Export von CSP-Technologien in die "Sunbelt"-Regionen bietet große Chancen für deutsche Anlagenbauer. So sind u.a. Schott Solar, die Ferrostaal Group mit ihrem Geschäftssegment "Solar Energy", Flagsol, die Solar Power Group, Solar Millenium und Fichtner Solar auf dem Gebiet CSP aktiv. Schott Solar (Receiver) und Flabeg (Spiegel) haben eine weltweit führende Markstellung inne. Große deutsche Energieversorger und Anlagenbauer wie E.On, RWE und Siemens gehören zum Industriekonsortium der Desertec Industrial Initiative, die den Ausbau von CSP in der MENA-Region vorantreiben will. Die Initiative wurde von der Münchener Rück angestoßen.
In diesem Artikel wird dargestellt, welche Aktivitäten deutsche Unternehmen entlang der Wertschöpfungskette bislang aufweisen und wie ihre Marktstellung im Vergleich zu führenden internationalen Unternehmen zu bewerten ist. Anschließend wird auf Basis von vorliegenden Energieszenarien ermittelt, welche messbaren ökonomischen Effekte für deutsche Unternehmen, z.B. zusätzliche Wertschöpfung und die Schaffung neuer Arbeitsplätze, aus den genannen Potentialen resultieren. Die Ergebnisse basieren auf einer Studie des Wuppertal Instituts, die im Auftrag von Greenpeace Deutschland und der DESERTEC Foundation erstellt wurde.
The study presents the results of an integrated assessment of carbon capture and storage (CCS) in the power plant sector in Germany, with special emphasis on the competition with renewable energy technologies. Assessment dimensions comprise technical, economic and environmental aspects, long-term scenario analysis, the role of stakeholders and public acceptance and regulatory issues. The results lead to the overall conclusion that there might not necessarily be a need to focus additionally on CCS in the power plant sector. Even in case of ambitious climate protection targets, current energy policy priorities (expansion of renewable energies and combined heat and power plants as well as enhanced energy productivity) result in a limited demand for CCS. In case that the large energy saving potential aimed for can only partly be implemented, the rising gap in CO2 reduction could only be closed by setting up a CCS-maximum strategy. In this case, up to 22% (41 GW) of the totally installed load in 2050 could be based on CCS. Assuming a more realistic scenario variant applying CCS to only 20 GW or lower would not be sufficient to reach the envisaged climate targets in the electricity sector. Furthermore, the growing public opposition against CO2 storage projects appears as a key barrier, supplemented by major uncertainties concerning the estimation of storage potentials, the long-term cost development as well as the environmental burdens which abound when applying a life-cycle approach. However, recently, alternative applications are being increasingly considered–that is the capture of CO2 at industrial point sources and biomass based energy production (electricity, heat and fuels) where assessment studies for exploring the potentials, limits and requirements for commercial use are missing so far. Globally, CCS at power plants might be an important climate protection technology: coal-consuming countries such as China and India are increasingly moving centre stage into the debate. Here, similar investigations on the development and the integration of both, CCS and renewable energies, into the individual energy system structures of such countries would be reasonable.
The North African countries Morocco, Algeria, Tunisia, Libya and Egypt have been and are currently experiencing rapid growth in energy demand. This development confronts their political leaders with the question of how to expand or diversify their countries' generation capacities. In this context, renewable energies and nuclear power constitute options that have rarely been exploited so far in the region. This article analyzes the drawbacks and benefits of both alternatives, with a special focus on import and export dynamics. When attempting to make the strategic decision between renewables and atomic power, North African regional specifics and circumstances have to be taken into account. Hence, in a first step, the article characterizes the energy systems of the North African countries and presents scenarios for their future development. In a second step, it scrutinizes the energy challenges these states face in terms of domestic concerns and foreign affairs. Finally, a case study of Algeria is used to demonstrate how renewable energies, but not nuclear power, are able to respond to North African energy challenges.